How to Fix Error 0xc0000098

How to Fix Error 0xc0000098

March 8, 2021

BLOG

Description How to Fix Error 0xc0000098


After discussing How to Fix Error 0x8007007e, this time the admin will discuss How to Fix Error 0xc0000098 Some users reported that they had encountered error 0xc0000098 after cloning the OS or upgrading Windows 10. This error caused them to not boot Windows.

When error 0xc0000098 occurs, you may receive the following error message: “Your PC / Device needs to be repaired. The Windows Boot Configuration Data file does not contain a valid OS entry. File: \ Boot \ BCD. Error code: 0xc0000098”

Sometimes, the file name will be replaced with certain system files like ntoskrnl.exe, winload.exe, Ntfs. sys, aswVmm.sys, etc.

You may be wondering what causes error 0xc0000098. One of the most common causes is that BCD has no entry.

Another reason for this error is incompatible hard drive drivers. For example, both the Ntfs.sys and aswVmm.sys mentioned above are driver types.

How to Fix Error 0xc0000098

Method 1. Run Startup Repair

Startup Repair will fix problems that are preventing your computer from booting up properly. So, you can try this method first.

Step 1: Boot the computer using Windows recovery disk

– Insert the Windows recovery disk into the computer.

– Restart the computer and follow the instructions that appear on the screen after booting the computer to enter the Firmware.

– Find the option that controls the computer boot order and then select Removable Devices as the first boot device.

– Save changes and restart the computer

Step 2: Follow the installation wizard until you reach Windows Setup. Then, click on Repair Your Computer to enter Windows recovery.

Step 3: Navigate to Troubleshoot> Advanced options> Startup Repair

Method 2. Check Disk

If there are errors on the C partition such as a problematic file system, bad sectors, etc. Error 0xc0000098 can also occur. Therefore, you can try running a check disk to fix it. Check out the following steps:

Step 1: Re-enter Windows recovery to open a Command Prompt window.

Step 2: Enter the following command line chkdsk c: / f. Then, the error will be corrected automatically if it is detected.

Method 3. Rebuild BCD

If the above method didn’t work, you will have to fix the BCD error manually via the following steps:

Step 1: Open a Command Prompt window in Windows recovery.

Step 2: Enter the following command lines one by one. These commands will fix BCD errors.

Bootrec / fixmbr
Bootrec / fixboot
Bootrec / rebuildbcd

Method 4. Run SFC

If it doesn’t work to rebuild the BCD or the 0xc0000098 error is still there, you can use SFC (System File Checker) to replace the corrupted system files. Please refer to the following steps:

Step 1: Open a Command Prompt window.

Step 2: Enter the following command line: SFC / scannow.

Method 5. Restore or Reset PC

If all the methods above didn’t work, you can restore or reset the PC. A system restore can fix certain computer crashes or other computer problems and return the computer to the state it was in before the error occurred.

Fix 6. Clean Installation

Some users reported that they only had three recovery options: Turn off PC, Startup Repair, and Command Prompt. There are no other recovery options when they boot the computer with Windows installation media.

If you are facing the same situation and the methods above were unable to help solve the 0xc0000098 error, it looks like you should do a clean install.

That’s the article on How to Fix Error 0xc0000098 Hope it is useful.

Recommended for you

Comments

One response to “How to Fix Error 0xc0000098”

Leave a Reply

Your email address will not be published. Required fields are marked *